Installation Instructions
for Laminate Flooring
Begin laying in the left-hand corner. Place the floorboard 4-6 mm from the left wall. The distance to the wall in front (4-6 mm) is not important because the flooring can be pushed into place at a later stage.
Press the end section of the next floorboard at an angle to the first one, then lay down. Complete the first row in the same matter
Place the final floorboard face down and the short side without the locking strip towards the wall. The distance to the wall should be 4-6 mm. Mark where the floorboard is to be cut.
Place the floorboard face down on the work surface and cut to size using a pad under 1 saw. Use a fine-toothed type if you are using a hand saw. In this case, cut the floorboards face up.
Use a cut piece of board from the previous row to start the next row. This must be at least 3- cm long. If the piece is to short, start with a new board, cut in half. Always ensure that the end joints are staggered at least 30 cm.
Place the floorboard at an angle against the floorboard in the previous row, press forward and fold down at the same time.
Place the next the floorboard at an angle against the previous installed floorboard and push it against the row in front. Put it down when the floorboards are positioned tightly.
The distance to the walls can be adjusted when three rows are completed. Place the flooring 4-6 mm from the walls.